JAWS 1 oz. Spit Antifog Lens Gel 6-Pack
- ECO friendly, non-toxic formula
- Long lasting gel formula
- Natural and biodegradable
- Works on glass and plastic
- Use for wet or dry applications
- Only use one "BB" size drop
- NOTE: Do not use this product on goggles
Instructions
WATER SPORTS APPLICATION (WET):
NOTE: JAWS spit anti-fog gel formula is not recommended for use on small lenses such as swim goggles. For products with smaller size lenses, use JAWS Quick spit anti-fog spray formula. All JAWS anti-fogs work with wet or dry applications. It is important to only use a WET application when using the product for WATER sports activities. Overusing the product DOES NOT improve its performance and is counterproductive.
- When you are applying to a glass lens be sure the lens has been pre-cleaned with JAWS scrub mask cleaner product prior to applying the anti-fog. By pre-cleaning the lens you are removing any factory coatings, foreign buildup or objects leaving a smooth, clean surface. Anti-fog will perform much better on a clean surface. New glass lens masks must be cleaned with scrub in order for the anti-fog to work properly.
- When you are applying on a plastic, polycarbonate or acrylic style lens be sure to rinse, dunk or wash it first ensuring there is no foreign buildup or objects on the lens. Anti-fog always works better on a smooth, clean lens.
- Apply a VERY SMALL amount of anti-fog on the inside of the lens. Seriously... it only takes a tiny bit so do not over apply! Rub the anti-fog over the entire area with your finger - then, it is important to rinse the product off the lens leaving no residue. Visually check each lens prior to use to ensure there is no product left on the lens. Remember... the job of an anti-fog is to relieve surface tension on the lens so fog (or tiny water molecules) cannot collect or stick to the lens.
NOTE: Do not use the DRY application method for any water sports activities. As stated above, all JAWS anti-fogs work with wet or dry applications. It is important to only use a DRY application when using the product for LAND sports activities. As with wet applications, overusing the product DOES NOT improve its performance and is counterproductive. NOTE: JAWS recommends Quick spit and SEESafe for dry applications.
- When you are applying on a glass, plastic, polycarbonate or acrylic style surface be sure the surface is clean. Both Quick spit and SEESafe can be used to pre-clean the surface prior to applying the product as an anti-fog (2-in-1 Formula). Simply apply Quick spit or SEESafe to the inside and outside of the lens, add water and wash with fingers or a clean damp cloth. Be sure to dry the surface after cleaning prior to applying the product as an anti-fog.
- Spray a small amount on the dry surface being treated. A larger surface will require more product but over applying is counterproductive. Rub or spread the anti-fog over the entire area. The product does not have to dry in order to perform properly on most surfaces but if you have time, allow it to dry (approximately 5-10 minutes). Then, gently buff with a JAWScloth or a clean, lint free, soft cloth only until product haze disappears. It is important not to over buff!
